Get free quotes

Free pump calculator

Pressure tank size calculator

Give the pump's flow and the pressure switch settings. It works out the usable water per cycle, the tank size that stops the pump starting too often, the air pre-charge and the worst-case starts per hour.

Pump and pressure switch

1 m³/h is 1,000 litres an hour, or about 16.7 litres a minute.

Check the motor's starts per hour in its manual.

Result

Pump flow
-
Water drawn per cycle
-
Usable share of the tank
-
Tank size needed
-
Next standard size
-
Air pre-charge
-
Worst case starts per hour
-

How the tank size is worked out

A pressure tank holds water against a cushion of air. When the pump stops at the cut-out pressure, the tank pushes water out until the pressure falls to the cut-in pressure and the pump starts again. Only part of the tank's volume comes out in each cycle: the drawdown.

By Boyle's law, the usable share is (cut-out − cut-in) ÷ (cut-out + 1.013), with the pressures in bar on the gauge and 1.013 bar for the atmosphere, when the air pre-charge is set just under the cut-in. At 2 and 3.5 bar, that is about 33% of the tank.

For the pump to run at least the time you chose on each start, the drawdown must be at least the pump's flow × that time. The tank size is the drawdown ÷ the usable share. The worst case for starts is when the house uses exactly half the pump's flow: then the pump starts 60 × flow ÷ (4 × drawdown) times an hour.

Setting up and checking a tank

  • Set the air pre-charge with the pump off and the tank empty of water, about 0.2 bar under the cut-in pressure, with a tyre gauge on the valve.
  • A pump that clicks on and off every few seconds, or a valve that spits water, usually means a burst membrane or a tank that has lost its air.
  • Big tanks cost more but save starts, which is what wears motors and contacts. Small motors are often allowed more starts per hour than large ones.

See pressure tanks and booster pumps, or the troubleshooting guide if the pump keeps switching.

Frequently asked questions

What size pressure tank do I need for a house?
It depends on the pump flow and the switch settings, not the size of the house. A pump giving about 40 litres a minute at 2 and 3.5 bar needs a tank of about 120 litres for a one minute run; a smaller tank means more starts.
What should the air pressure in a pressure tank be?
About 0.2 bar below the cut-in pressure of the pressure switch, checked with the pump off and the water drained out of the tank.
Can I use two small tanks instead of one big one?
Yes. Tanks fitted side by side on one manifold add up their drawdown, as long as each has the same pre-charge.

More calculators and guides

Free quote request, no obligation

Request pressure tanks quotes

Fill in the duty sheet the way a pump technician would: how deep the water is, how high it must go, how much you need, or what has to be pumped away. Pump suppliers, installers and repairers in your area quote you directly.

Pump duty sheetPressure Tanks
Request
85964
Logged
2026-11-21

1The job

2How many (optional, it helps the quote)

Your ordernot to scale

-
-
-
-
-
-
Estimate
-

A rule of thumb, not a pump selection.

3Power and timing

4Your list (optional)

  1. 01
  2. 02
Up to 12 lines: pumps, boxes, cable, pipe or spares.
Needs and options

5Your details

Free and no obligation. By sending you agree that we may share your request with suitable suppliers, installers and repairers. See our privacy policy.

Get free pump quotes